Want better posture, more strength in pressing movements, more mobile shoulders, and a more impressive-looking upper body — from all angles? There’s a single move that can get you there that you’re almost certainly not doing: the cable rear delt fly.
This simple, little-used exercise grows and strengthens the rear delts, a band of muscle that pulls your shoulder and upper arm backwards and, when strengthened, provides a host of other benefits as well.
Cable Rear Delt Fly: Step-by-Step Instructions
- Select a light weight on both stacks of a dual cable machine, and slide the pulleys to around shoulder height.
- Face the machine and take hold of the cable for the stack on the right in your left hand and the cable for the stack on the left in your right hand (the cables will be crossed in front of you).
- Still facing the machine, assume a kneeling position — on a pad if necessary — about two feet behind the front stacks of the cable machine.
- Reach your arms directly forward and upward in front of you, about 45 degrees to the floor. This is your starting position.
- Keeping your arms slightly bent, slowly draw the cables in wide arcs down and behind you, squeezing your rear deltoids as hard as possible in the end position (think of pushing the pinkie-sides of your hands down and outward).
- Slowly reverse the movement, return to the starting position, and repeat for reps.
Cable Rear Delt Fly Muscles Worked
Compared to bigger lifts like the bench press, squat, or deadlift, the cable rear delt fly works small — but important — muscles that are often overlooked.
Rear delts
The rear delts originate at the top of your scapulae (shoulder blades) and insert, or attach, to the back of your upper arm a few inches below your shoulder joint.
The function of this understated chunk of sinew is to pull your upper arm from a shoulder-height position in front of your body to a point behind your upper body in the same plane, a move known as horizontal abduction.
The rear deltoids also rotate your upper arms outward (away from the center line of your body), a movement technically termed external rotation.
Trapezius
To a lesser degree, cable rear delt flys also work the lower portion of the trapezius muscles — the kite-shaped muscle that spans your mid and upper back — which help draw your shoulder blades downward.
Small as they are, however, the rear delts and lower traps are crucial to shoulder function and posture. They counterbalance the action of the upper trapezius (which shrug the shoulders) and the pec muscles of the chest (which pull your shoulders forward and rotate your arms internally).
Cable Rear Delt Fly Benefits
Here are a couple reasons why cable rear delt flys deserve a place in your training.
Prevents muscle imbalances
The deltoids are a three-headed muscle responsible for raising your arm in numerous ways. Among workout regulars, the rear delts are by far the most-neglected: The front delts get plenty of direct action from pressing moves of all kinds — pushups, bench presses, overhead presses, and the like — and the side delts get tons of love from lateral raises.
However, the rear delts typically get only indirect work from back moves like rows and pulldowns. This can lead to imbalances among the heads of your deltoids, limiting their strength and growth potential. The rear delt cable fly can help with that.
Improves posture and shoulder function
Underdeveloped rear delts can also lead to a forward-rounded posture that, over time, can cause pain in your neck and back, and poor function in the shoulder joint.
A few sets of cable rear delt flys every week can help pull you out of the shrugged-shouldered, rounded-back position that many of us habitually assume throughout much of the day. This will help improve day-to-day posture while allowing you to reach your arm overhead more comfortably and press more weight overhead in your upper-body workouts.
Rear Delt Cable Fly Alternatives
The rear delt cable fly isn’t the only effective exercise for this underappreciated muscle. But it is one of the best, as it challenges the muscle through its entire range of motion, from the stretched position to the fully contracted position.
Most rear-delt moves are primarily effective when your rear delts are shortened — or fully contracted — but are less effective in the lengthened position. This is true of the dumbbell reverse fly, which is challenging when the dumbbells are fully lifted, but very easy — almost effortless — when your arms are hanging straight down.
This doesn’t make these alternative moves ineffective. You’ll certainly build and strengthen your rear delts using the moves listed below. They’re just somewhat less effective than the cable version.
1. Dumbbell reverse fly
- Stand with your feet shoulder-width apart, holding a dumbbell in each hand.
- Hinge at the hips (press the hips back as you lower your chest) until your chest is almost parallel with the ground. Allow the weights to hang straight down at arm’s length, palms facing each other.
- Keeping your back flat and your core braced, raise your arms out to your sides until they’re in line with your body. Squeeze your shoulder blades together at the top of the movement.
- Return to the starting position, and repeat.
2. Resistance band reverse fly
- Hold the handles of a resistance band and assume a shoulder width stance, using both feet to stand on the center of the band to secure it.
- Exchange handles between your two hands so that the bands cross.
- Bend your knees slightly and hinge at your hips until your torso is almost parallel to the floor and your back is flat. (If necessary, spread your feet wider to create more tension on the band.)
- Keeping your torso still, raise the handles as far as possible directly out to your sides, with the back of your hands facing the ceiling.
- Lower the handles fully, and repeat.
3. Resistance band face pull
- Anchor a resistance band to a stable point several inches above your head.
- Facing the anchor point, grab the band with an overhand grip, keeping your hands about six inches apart.
- Step back from the anchor point with your arms extended in front of you until you feel tension in the band.
- Keeping your back straight and elbows high, pull the band toward your face, stopping once the band approaches your nose.
- Slowly reverse the move to return to the starting position, and repeat for reps.
4. Dumbbell YTI raise
- Lie face-down on a stability ball or bench holding a dumbbell in each hand. Let your arms hang straight toward the floor, palms facing each other.
- Keeping your head neutral, raise both arms at 45 degrees to form a “Y” shape. Pause briefly. Then, lower the weights back to the starting position.
- Lift the weights again, this time straight out to your sides to form a “T” shape, palms facing down. Pause briefly at the top of the movement before lowering the weights.
- Finally, lift the weights by extending them straight behind you to create an “I” shape, palms facing each other. Hold briefly and lower the weights.
- Repeat the entire sequence for the desired number of reps.